HYGHSPIN Engineered twin screw pump
HYGHSPIN Engineered — a HYGHSPIN twin screw pump configured to the customer's specification on the basis of the standard versions. Sizes 70, 90, 105 and 125. Flow rate up to 350 m³/h, differential pressure up to 50 bar.
What can be changed in HYGHSPIN Engineered?
The modular system of the series allows you to combine:
- flange variants and port arrangements;
- seals and elastomers;
- drives and installation positions;
- feed screw pitch.
Which special versions are available for HYGHSPIN Engineered?
| Parameter | Value |
|---|---|
| Heating | heated inlet and outlet ports; heated or cooled casing |
| Casing seal | with steam barrier |
| Wear resistance | special hardening and coatings |
| Special materials | duplex steel 1.4462, super-austenitic steel 1.4539, nickel-based alloys |
| Drive | hygienic stainless steel motor for cleanrooms |
| Explosion protection | ATEX version, temperature classes T2–T4 |
| Condition monitoring | temperature and vibration sensors |
| Contents | mobile units with control system, tanks and measuring instruments |
Which shaft seals can be selected?
| Gaskets | A distinctive feature |
|---|---|
| Double mechanical seal, flushed | safe for dry running |
| Double mechanical seal with barrier fluid | the pressurised chamber prevents product escaping; meets TA Luft requirements |
| Single mechanical seal | no flushing fluid, so the product is not contaminated by it |
| Lip seal | dry-run safe without flushing; suitable for mobile pumps |
Flushing is connected in one of two schemes. Circulating flush — chambers in parallel, minimal pressure loss. Loss flush — chambers in series, the flushing fluid is not returned. All mechanical seals are semi-cartridge units.
When is HYGHSPIN Engineered needed?
When the standard HYGHSPIN, Extended, Double Flow or Hopper versions do not cover the task. Typical reasons are a non-standard connection, a product that solidifies, higher material requirements, a hazardous area or the need for a ready mobile unit. Materials, elastomers, shaft seals and certificates are common to the whole range — see the Jung Process Systems page.
Selection and service from Steiner Ukraine
For a HYGHSPIN Engineered specification, we clarify:
- the product, temperature mode and need for heating;
- material and wear resistance requirements;
- installation area — cleanroom, ATEX;
- seal type and flushing scheme;
- unit scope: frame, tank, controls, instrumentation.
Based on these data we define the size, version and seal. Then come supply, service and spare parts. Steiner Ukraine has been operating in the industrial equipment market since 2006.
FAQ about HYGHSPIN Engineered
What is the maximum flow rate of HYGHSPIN Engineered?
Approximately 350 m³/h at differential pressures up to 50 bar.
Can HYGHSPIN be ordered on a mobile frame?
Yes. The manufacturer supplies mobile units with control system, tanks and measuring instruments.
Which seal to choose for a mobile pump?
The manufacturer recommends a lip seal: it is dry-run safe and needs no flushing.
Does the pump meet TA Luft requirements?
Yes, in the version with a double mechanical seal with barrier fluid.
Manufacturer: Jung Process Systems
Category: Twin screw pumps
Industries: Food, Beverages, Pet food, Pharma, Cosmetics
Model range: 4 sizes: 70, 90, 105, 125
